In every flowsheet, you are able to select set critical values for each numeric Monitoring parameter (such as Temperature or Heart rate). To enter critical parameters, follow the steps below:


From the web

Open the required flowsheet > click on the parameter for which you want to set the critical values (e.g. Temperature) > enter Critical values > and then Done:


From the iPad

Open the required flowsheet > go Editing mode (tap pencil icon in the upper right corner) > tap on the parameter foe which you want to set the critical values (e.g. Temperature):


In the two boxes for Critical values enter the low and high-end critical values you desire and tap Done:


NOTE: You will need to click Done twice. First to finalize the entrance of the new values in the field, and then to save the changes for the whole Temperature parameter.


Save the changes by tapping the floppy disk icon in the upper right corner and use the flowsheet as usual.


NOTE: When entering a value out of the Critical values range, an alert will appear on both the web and iPad and the value will be highlighted in red:

On the web

On the iPad


The same information can be seen in the Medical Records pdf:


If you set Critical Values for each Monitoring parameter and save this as a Treatment Template, they will be saved for further use. After you create this template, you may also change the critical parameters for an individual patient without those changes being saved to the Template.


We hope you found this information useful!