Medications on the flowsheet can be displayed in dosage, total dose (ie, in mg) or total volume. You can set your SmartFlow account to default to a preferred display type.


In order to make desired changes, you need to open the settings page of your SmartFlow web account > go to Settings > General > Medication Units. There you can toggle the switch to your preferred choice: 


You can also customize the display of medication units for any medication on your flowsheet individually. This can be done both from the Web and iPad. 


From the Web

Go to any patient's flowsheet and click on the name of a needed medication. Then, you will see a pop-up window. Toggle it to your preferred choice and hit Done:


From the iPad

Open patient's flowsheet and access the Editing mode, by taping on the pencil icon in the upper right corner of the screen:


Then tap on a needed medication > switch the Display toggle to your preferred choice and press Done:


NOTE: Don't forget to exit the Editing mode and save the changes you made by tapping on a floppy disk icon in the upper right corner of the screen. 


We hope you found this information useful!